Openocd manual 0.4.0

By ernestw - Wed Dec 01, pm. Should be "flash bank myflashbankname 0 0 0 0 at91sam7s. You should also have the following lines at the end of the last cfg. Leave the init and halt commands as your last lines. When you get these everything working to the point of the halt command then you can start to look at the specific instructions to flash the memory. At the moment OpenOCD is not working. If you are using Vista or Windows 7 you may have trouble with the device driver. See my previous post - it may help.

By Rockford - Wed Dec 01, pm. I will do what you're telling me to. I'm still messing around with it. Code: Select all Debug: 11 command. Code: Select all openocd -d3 -l mylogfile. Code: Select all Error: status register: 0x Error: Lock Error Bit Detected, Operation Abort Error: error writing to flash at address 0x at offset 0x details from logfile: Debug: target.

Code: Select all flash protect 0 0 1 off. Code: Select all Warn : srst pulls trst - can not reset into halted mode. Issuing halt after reset. By Rockford - Sat Dec 04, am. It seems that the stuff I get to compile without errors does not do anything useful. I used a mixture between afinko's configuration file and sam7x Here it is, I call it sam7-p Options 20 posts 1 2 Next Page 1 of 2 20 posts. We have created lots of YouTube videos just so you can achieve [ The best flat phpBB theme around.

Take note of the bit hexadecimal value the one with 0x followed by 8 digits in the first two lines, and the expected value in the third line. The found tap ID is 0xd and the expected tap ID is 0xffffffff.

You will need these values in step 3. Find the config file for your board. The config file for your board is hammer. Open the config file in a text editor. Find a line that calls the config file for your processor. It should look like this:. For the Hammer, the file should now read like this:. Permalink master. Branches Tags. Could not load branches. Could not load tags. Raw Blame. Open with Desktop View raw View blame. This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below.

To review, open the file in an editor that reveals hidden Unicode characters. Learn more about bidirectional Unicode characters Show hidden characters. You signed in with another tab or window.